Search by property

From CSDMS

This page provides a simple browsing interface for finding entities described by a property and a named value. Other available search interfaces include the page property search, and the ask query builder.

Search by property

A list of all pages that have property "Describe processes" with value "TOPMODEL is defined as a variable contributing area conceptual model in which the dynamics of surface and subsurface saturated areas is estimated on the basis of storage discharge relationships established from a simplified steady state theory for downslope saturated zone flows. The theory assumes that the local hydraulic gradient is equal to the local surface slope and implies that all points with the same value of the topographic index, a/tan B will respond in a hydrologically similar way. This index is derived from the basin topography, where a is the drained area per unit contour length and tan B is the slope of the ground surface at the location. Thus the model need make calculations only for representative values of the index. The results may then be mapped back into space by knowledge of the pattern of the index derived from a topographic analysis.". Since there have been only a few results, also nearby values are displayed.

Showing below up to 2 results starting with #1.

View (previous 50 | next 50) (20 | 50 | 100 | 250 | 500)


    

List of results

    • Model:TOPMODEL  + (TOPMODEL is defined as a variable contribuTOPMODEL is defined as a variable contributing area conceptual model in which the dynamics of surface and subsurface saturated areas is estimated on the basis of storage discharge relationships established from a simplified steady state theory for downslope saturated zone flows. The theory assumes that the local hydraulic gradient is equal to the local surface slope and implies that all points with the same value of the topographic index, a/tan B will respond in a hydrologically similar way. This index is derived from the basin topography, where a is the drained area per unit contour length and tan B is the slope of the ground surface at the location. Thus the model need make calculations only for representative values of the index. The results may then be mapped back into space by knowledge of the pattern of the index derived from a topographic analysis.index derived from a topographic analysis.)